矩形光脉冲光电响应后沿拖曳性状研究

本文对矩形光脉冲光电响应后沿拖曳的形成机制进行了详尽的实验研究和理论分析，认为形成该光电响应时滞后曳的主要根源在于光生电子与空穴的多声子慢态复合．我们给出了削减后沿拖曳、提高光电响应速度的有效措施，从而促进解决宽带光通讯的速度瓶颈问题．     

硫脲型整合树脂在分析上的应用 Ⅰ.岩样中微量银的中子活化分析

前言银和其他贵金属元素一样,在地壳中比较稀少,按其自然丰度为第67号元素,平均含量仅0.07 ppm。由于地质样品成分非常复杂,为测定其微量银,必须进行严格的化学分离。但是迄今文献中报道的许多分离分法,步骤都相当冗长,一般采用氯化银反     

提高储层预测精度技术思路与对策

采用地质、地震、测井人员协同一体化作业，对地下地质目标进行综合预测与评价，可提高储层预测精度，降低预测结果的多解性。主要方法是针对不同的区块，采用不同的方法和对策，首先从单井储层划分对比入手，建立储层沉积模式，同时对地震数据目的层段进行精细解释，建立地层构造模式，用沉积、构造等地质规律来指导和约束反演；利用测井资料对地震资料进行精细标定，建立各井的单井波阻抗模型，建立井数据和地震数据沟通的桥梁；在严格的测井约束、地质模型约束、层位控制下进行储层反演；充分利用地质、地震反演结果、地震参数提取及分析结果、测井、测试和分析化验等资料对储层预测结果进行综合分析与评价。该方法应用于长庆、大庆、准噶尔等实际区块，取得了较好的效果。     

The Effect of Post-Cooking Holding Times on Sensory Assessment of Low- and High-Fat Beefburgers

ABSTRACT: The effect of post-cooking holding-time on sensory assessment of low (89 g/kg) and high (218 g/kg) fat beefburgers was assessed. Burgers were served to panelists approximately 3 or 18 min after cooking. Fat content influenced fattiness, moistness/juiciness and overall appearance (P < 0.05), overall acceptability and overall texture (P< 0.01) and tenderness and crumbliness (p<0.001). Burgers with the higher fat content had higher scores. Holding-time influenced sensory overall appearance only with lower scores at extended holding times (P < 0.01). Treatment differences were small, mostly less than one sensory scale unit. Higher lightness and yellowness values were found for burgers with higher fat contents.     

Ionoluminescence decay measured with single ions

A new ion beam analysis-based, single ion technique called the time to first photon has been developed to measure the decay of the luminescence signal of phosphors. Such measurements are currently needed to study luminescence decay mechanisms following high-density excitations and to identify strongly luminescent phosphor coatings with short lifetimes for ion photon emission microscopy (IPEM). The samples for this technique consist of thin phosphor layers placed or coated on the surface of PIN diodes. Single ions from an accelerator strike this sample and simultaneously create ion beam induced luminescence (IBIL) from the phosphor that is measured by a single-photon-detector, and an ion beam induced charge collection (IBICC) signal in the PIN diode. In this case, the IBICC signal provides the start pulse and the IBIL signal the stop pulse to a time to amplitude converter. It is straightforward to show that this approach also measures a signal proportional to activity versus time with an accuracy of 5% as long as the number of detected photons per ion is less than 0.1, which usually requires the use of absorbers for the IBIL detector or electronic discrimination for the IBIL signals. Details of the new analysis are given together with examples of luminescence decay measurements of several ceramic phosphors being considered to coat IPEM samples. IPEM is currently being developed at Sandia National Laboratory (SNL), the University of North Texas in Denton, and the Universities and INFN of Padova and Torino.     

Development of nano indium tin oxide (ITO) grains by alkaline hydrolysis of In(III) and Sn(IV) salts

Indium tin oxide (ITO) nano powders of different compositions (In: Sn = 90: 10, 70: 30 and 50: 50) were prepared by heat treatment (300-450°C) of mixed hydroxides of In(III) and Sn(IV). The hydroxides were obtained by the reaction of aq. NH₃ with mixed aq. solutions of In(NO₃)₃ and SnCl₄. FTIR and TG/DTA studies revealed that powders existed as In(OH)₃H₂O—SnO₃H₂H₂O in the solid state and then they transformed to In₂O₃—SnO₂ via some metastable intermediates after 300°C. Cubic phase of In₂O₃ was identified by XRD for the oxides up to 30% of Sn. Particle size measurements of the solid dispersed in acetone and SEM study for microstructure showed that the oxides were in the nano range (55-75 nm) whereas the size range determined from Debye-Scherrer equation were 11–24 nm.     

加油站油品常见质量事故分析

分析了中油站产生一些油品质量事故的情况和成因。指出加油站油品的质量事故主要是管理不善，要杜绝加油站油品质量事故，必须坚持执行《中国石油化工集团销售企业油品质管理办法》。     

紧凑型FLC光纤PDL模块

描述了紧凑型FLC（铁电液晶）光纤PDL（光子延迟线）模块的结构和运转特性；分析了插入损失；提出多信道运转时依赖于波长的设计方案。     

Accurate depth profiling through energy-dependent pulse height deficit compensation in gas ionization detectors

The impact of the pulse height deficit effect in gas ionization detectors on the accurate extraction of depth information from heavy ion elastic recoil detection spectra has been investigated. Thin GaN films and Ge_xSi_1−x/Si heterostructures have been analyzed with a 200 MeV ¹⁹⁷Au beam. Employing an empirical parameterisation of the pulse height deficit, a global energy calibration of the detector can be achieved. Energy spectra have been compared, calibrated with either a constant or a full energy-dependent compensation for the deficit. A constant compensation results in significant distortion of the extracted depth profile for heavier ions, whereas an energy-dependent compensation yields true concentration–depth profiles.     

检测骨架图形特征点的新方法

端点、折点、歧点和交点是骨架图形的重要特点是，提出用快速查表法检测侯选特征点，再进行侯选特征点聚集，用局部结构分析，去除假特征点，判别真特征点的类型，并对折点给以大致的定量描述。实验结果表明，该方法能快速有效地找出骨架图形的特征点，在目标识别、字符识别等应用中起着关键作用。